How do you tighten a fan belt?

Tighten the locking nut or bolt and the lock washer to 455ft-lb (61bm) of torque so that the tensioner or bracket is fastened. 1. Loosen the large locking nut on the fan hub or fasten the fan hub to the bolt on the mounting bracket. After this work is done, the fan hub will deviate. 2. Turn the adjusting bolt to increase the tension of the belt. 3.

How do you install a generator on a used engine?

Note: When installing a generator to a used engine, remove the flywheel and visually inspect the rear crankshaft seal for any sign of oil leakage, and replace the seal if needed. After replacement of the flywheel, check it with dial indicator to insure it is installed correctly and running true.

How do I install a generator hook-up?

A licensed electrician should perform a generator hook-up installation, but here are the general steps involved in the installation. Call the local utility company to shut off the power to the panel. They’ll pull the meter and then test it to ensure there is no power feeding the panel from the utility company.

How do you attach a front adapter to a generator?

Every generator maker has a method for attaching the front adapter to the generator. In the case of this Marathon unit, there is a clever system of dogs that allow quick adapter change. All it takes to bolt on the adapter is replacement of the dogs and their bolts after the new adapter is in place.

How do you install a generator drive plate?

Slowly move the generator drive plates onto the studs until the plates bottom in the flywheel. When the plates are bottomed put two bolts in the generator flange outer circle of bolts (only finger tight). Next remove the line-up studs and begin nstalling the drive plate bolts, again finger tight, one at a time, until they are all installed.

Can a master electrician install a generator transfer switch?

Master electrician Heath Eastman helps a homeowner install a generator transfer switch in his home. While extension cords might do the trick, there’s a better and safer way to run a generator when the power is out—transfer switches. Master electrician Heath Eastman helps a homeowner install a set in his home.